berrien buggy steering column support & windshield insta

Gene-C · Post by **Gene-C** » Wed Jan 25, 2006 6:36 am

The above pic is exactually how it mounts in the car. Picture standing in front of the car looking towards the rear, with the hood off. The cardboard templates position the brace perfectly. I am serious...I installed mine in 10-15 minutes. MURZ

TMc2548 · Post by **TMc2548** » Thu Jan 26, 2006 4:44 am

Does this ws support also support the wiper assembly? Can it be modified to do so if not?

Gene-C · Post by **Gene-C** » Thu Jan 26, 2006 5:09 am

yes it is setup to support the ww assembly

Gene-C · Post by **Gene-C** » Fri Jan 27, 2006 11:08 pm

Here are some pics of how the brace sits in the car. Keep in mind that I ran my column UNDER the bar instead of on top to lower the column. hope this helps!!!...and yes the coulmn will be painted....eventually.

90volts · Post by **90volts** » Sat Jan 28, 2006 2:19 pm

ok- so i have to ask then-where is the 'windshield' in the "Berrien's Steering Column Support & Windshield Installation kit". looks like it should be berriens steering column support and windshield wiper support. by the way, great pics of the install. thanks-its very instructive.