Stressed out and stumped over new wiring
Posted: Sun Sep 11, 2016 7:30 pm
I've been trying to figure this out for several months now and am at wits end with it. My Sand Rover T is so close to road ready but this wiring thing is driving me crazy. The old wiring ended up being unsalvageable and I mad an entire new harness using the Empi kit, the colored wire diagram from the forums here, and a lot of help from pics and YouTube.
First off, I am not an electrician so that may be part of the issue. I've tried following the directions as best I can but still having issues.
Where I am now:
Headlights and brights are works fine
I have power coming through the fuse panel
The gen and oil pressure lights come on on the speedo
The starter turns over
The problem:
No turn signals whatsoever. Power is going into the relay
No hibeam or turn signal indicator lights on speedo
Engine doesn't seem to be getting spark so won't actually start
Possible problems: Power and ground issue with speedo? - wiring this is not clear
Short somewhere
I'm just not sure. I'm in Castaic, CA. Is there anyone local that I could buy lunch for that might be able to come by and take a look? It might be obvious to someone else but I seem to be missing the issue completely.
Also, not sure how to post pics here. Would like to show th speedo I'm using and current wiring situation.
Thanks
First off, I am not an electrician so that may be part of the issue. I've tried following the directions as best I can but still having issues.
Where I am now:
Headlights and brights are works fine
I have power coming through the fuse panel
The gen and oil pressure lights come on on the speedo
The starter turns over
The problem:
No turn signals whatsoever. Power is going into the relay
No hibeam or turn signal indicator lights on speedo
Engine doesn't seem to be getting spark so won't actually start
Possible problems: Power and ground issue with speedo? - wiring this is not clear
Short somewhere
I'm just not sure. I'm in Castaic, CA. Is there anyone local that I could buy lunch for that might be able to come by and take a look? It might be obvious to someone else but I seem to be missing the issue completely.
Also, not sure how to post pics here. Would like to show th speedo I'm using and current wiring situation.
Thanks