Page 2 of 2
Re: Wing mounting hardware
Posted: Sun Jan 17, 2016 7:19 pm
by jsturtlebuggy
Looks like it will work well for supporting the radiator.
Re: Wing mounting hardware
Posted: Sun Jan 17, 2016 9:22 pm
by Artie8804
If anyone needs the file I would be glad to share. I did some rough test pieces and they fit well, so these should go in nice. I will update on details once the are all prepped and in.
Re: Wing mounting hardware
Posted: Wed Jan 20, 2016 4:26 pm
by Artie8804
Re: Wing mounting hardware
Posted: Fri Jan 22, 2016 6:50 am
by Artie8804
Re: Wing mounting hardware
Posted: Fri Jan 22, 2016 6:54 am
by manxvair
How is the radiator held to the supports?
Re: Wing mounting hardware
Posted: Fri Jan 22, 2016 3:48 pm
by Artie8804
The radiator I bought had some 90* tabs welded to the sides. They sit on the bent sheet metal with rubber isolators in between.
Re: Wing mounting hardware
Posted: Wed Mar 02, 2016 7:04 am
by Artie8804
Re: Wing mounting hardware
Posted: Mon Feb 27, 2017 7:44 am
by Brad
IF ..... u are going to try and put them on a Manxter 2+2 make sure that you test fit with the radiator for sure BUT also make sure you have the engine in and mounted with the intake and TB etc on it. The clearance under the rear of the Manxter 2+2 is MUCH lower than the DS.
For example my Ej Series Buggy Exhausts does not fit a Manxter 2+2 with rear wing as the muffler touches the rear wing. In a DualSports it is no where near and I never thought it would hit. I have also had issues clearing the TB and Manifold when I setup using measurements as opposed from doing complete mock up.