Manx Club

that's the part...."an oil deflector" Does anyone have and extra end cap laying around, it's the last washer as the axle is buttoned up......

I need some help in locating a lost washer. The swing axle was taken apart a couple of years ago, and I seem to have lost the outside washer on the axle assembly. It's a thin steel washer that protects the rubber axle seal from the elements. If Anyone has an old Axle end cap, I sure would love to ge...

One more thought just crossed my mind. Are your fuel lines big enough to supply the needs of your system? I recall thet they need to be at least 6AN or larger for the system to operate. Your two problem flat spots sound like fuel starvation. Just off idle, then again at high RPMs. Jon

You got one hell of an engine from Aircooled Tech. Didn't realize we both have one special powerhouse.... If Jake built your engine, it should have several hours of running time on his dyno! I can't believe he didn't work out all the bugs in the system. Man, I'd be calling him tonight to work out al...

I've got an SDS System in a type IV 2270CC engine from Jake Raby at Aircooled Technology. Have not fired it up yet, but it's very straightfoward in it design. 1. A "tee"fitting from CB performance for the fuel tank. 2. A good electric fuel pump Mallory) 3. A Couple of good fuel filters (I'...

NUMBER THREE Great restroration job...... Think we all love to see someone drag a forgotten FDB home and bring it back to its glory!

Thanks For The Update

Back to my first statement! mount it to a cross bar! Here's where the roll cage mounts thru the FGB and has a hard point to the frame. only three holes on each side to contend with.... Outside and Inside shots Take a look at the whole roll cage at: http://users.adelphia.net./~jpboyton/

check out "Crow Enterprizes" at least you will see how far below your shoulder blades the straps must be. Don't have stainless but: I had a cross bar welded on the roll bar to anchor my belts. High enough to get your legs under, for those who rather ride in the rear. http://www.crowenterpr...

Number Four

Gary, Chassis is from Berrien, and the front beam is a Jamar adjustable aluminium unit.

Joseph, Saw that brake setup in the latest HOT VW mag.... thought I would also try it. Those rear bolts aren't even tightened up... they're just holding the tube up to put in the rear bearings. Thanks for the heads up, I'll flip them! This whole unit is getting fitted with a 2270cc TYPE IV EFI Airco...

Chassis is painted new gas cap placement in old hood full roll cage in place five wide discs front and rear mid tranny mounts Kafer brackets welded in place for the torque bars steering mounts next on the list

I was going to do the same and found that that chrome lever would bind up everywhere, both in up and in the down postion... even used the OEM guts and it still would'nt work, threw it out and put the old one back in. Back to your question! There is a small ring clips on either side of the pin, pop t...

This forum is really great thanks for the responses!! I thought I installed the axles in the tranny wrong.....